9ENHeadset installation• The ID-282H may be used with any industry standard two-band 2.5mmheadset, which must be purchased separately. Connect the he
EN10PROBLEMUnable to makea call -OUT OF RANGEappears on thehandsetUnable to make acall -NOT REGISTEREDappears on thehandsetUnable to enter thesubmenus
11ENCaller ID is notdisplayed during aCall Waiting callHandset doesnot ringKeys activatedwhile talkingMute, intercom andspeakerphonefeatures do not wo
EN12SAFETY INFORMATIONWarning! AT&T DOES NOT represent this unit to be waterproof. Toreduce the risk of fire, electrical shock, or damage to the
13EN11.Unplug this product from the wall jack and refer servicing toqualified service personnel under the following conditions:a)If liquid has been sp
EN142. Do not dispose of the battery pack in a fire; the cells may explode.Do not expose battery pack to water. Dispose of old, defective batterypack
15EN• Handle the handset gently and carefully. Dropping it can damagecircuit boards and cases and can cause it to malfunction.• Keep the handset away
EN16TYPE DESCRIPTIONHandset L x W x H 5.55 x 1.73 x 0.94 inHandset weight 4.41oz (with battery)Base L x W x H 3.68 x 3.13 x 1.50 inBase Weight 2.6 ozS
17ENThis equipment generates, uses, and can radiate radio frequency energyand, if not installed and used in accordance with the instructions, maycause
EN18RENs on a telephone line may result in the devices not ringing inresponse to an incoming call. In most but not all areas, the sum ofRENs should n
1ENTable of Contents...1Getting started...
19ENquestions about what will disable alarm equipment, consult AT&TCustomer Service or a qualified alarm company.k. Privacy of communications may
EN20transit to service facility. We do not warranty that the product will becompatible with any telephone equipment or systems or party lines.This wa
21ENQ&AWHAT DOES OUR WARRANTY COVER?• Any defect in material or workmanship.FOR HOW LONG AFTER THE ORIGINAL PURCHASE?• To the original purchaser
EN22• Products serviced by the owner or a service facility not expresslyauthorized by AT&T Communications.• Products purchased more than 12 months
EN2 GETTING STARTEDThe AT&T ID-282H Accessory Handset is for use with the AT&T ID-2820Digital Cordless Telephone with Touch Sensitive Keypad.
3ENSetup of the ID-282H Accessory Handset1.Plug the AC Adapter cord into the base unit and then into a walloutlet.2.Pull the battery contact tab out s
EN43.Touch to confirm.4.You will see the message: ‘REGISTERING...’. Press and hold thePAGE key on the cradle of the base unit.5. ‘REGISTRATION ACC
5ENTo adjust receiver / speakerphone volume:• Touch or during a call to raise or lower the volume.To make a call:1.Touch and wait for a dial to
EN63.The display will show 'DIAL' and 'DIAL 1+' options. Touch or to toggle between dialing a local call (DIAL) or a long dista
7EN8.Touch to confirm and save record.NOTE: A number can be saved without entering a name. Whenrequested to enter the name, press key and move t
EN8To page from base to handset(s):1.Press PAGE on the base unit .2.All of the handsets registered to the base will beep and the display willshow PAGI
Komentáře k této Příručce